Comments

Document Feedback - Review and Comment

Step 1 of 4: Comment on Document

How to make a comment?

1. Use this Protected Document to open a comment box for your chosen Section, Part, Heading or clause.

2. Type your feedback into the comments box and then click "save comment" button located in the lower-right of the comment box.

3. Do not open more than one comment box at the same time.

4. When you have finished making comments proceed to the next stage by clicking on the "Continue to Step 2" button at the very bottom of this page.

 

Important Information

During the comment process you are connected to a database. Like internet banking, the session that connects you to the database may time-out due to inactivity. If you do not have JavaScript running you will receive a message to advise you of the length of time before the time-out. If you have JavaScript enabled, the time-out is lengthy and should not cause difficulty, however you should note the following tips to avoid losing your comments or corrupting your entries:

  1. DO NOT jump between web pages/applications while logging comments.

  2. DO NOT log comments for more than one document at a time. Complete and submit all comments for one document before commenting on another.

  3. DO NOT leave your submission half way through. If you need to take a break, submit your current set of comments. The system will email you a copy of your comments so you can identify where you were up to and add to them later.

  4. DO NOT exit from the interface until you have completed all three stages of the submission process.

 

Contractor Safety Induction Policy

Section 1 - Purpose and Scope

(1) This Policy supports maintaining a secure campus environment by complying with the requirements of the Work Health & Safety Act 2011 for the protection of persons and the workplace. It defines the requirements and procedures under which contractors entering campus must undergo safety induction and registration of their presence on campus.

Scope

(2) This Policy applies to all staff, tenants and others requiring contractors to enter a campus.

Top of Page

Section 2 - Definition

(3) For the purposes of this Policy:

  1. Contractor
    1. A person or firm that contracts to supply materials, services or labour;
    2. A person or firm which provides professional or expert advice in a particular field (for example, consultancy services);
    3. A person (except an employee) engaged at a University Campus location to do any work for gain or reward.
Top of Page

Section 3 - Policy Statement

(4)  Individuals engaging a Contractor must ensure the Contractor Safety Procedure requirements are communicated, understood, and completed prior to the Contractor receiving approval to attend Campus

(5) Contractors must sign in upon arrival at either the Property Services or Security offices; where confirmation of Induction Completion will occur as well as obtaining the relevant identification and access requirements.

(6) In addition to these requirements, the Contractor must ensure the necessary Risk Assessment and Safe Work Method statements have been addressed and any Permits to Work have been completed before commencement.

Top of Page

Section 4 -  Procedures 

(7) Upon engaging a contractor(s), individuals must ensure that the contractor is advised of the following:

  1. all contractors, on entering a campus, must sign in and out of one of the following locations:
    1. Lismore - W Block, Property Services Office or the Military Road Gatehouse via online sign-in form;
    2. Gold Coast Campus – A Block, Property Services Office or Security Office; 
    3. National Marine Science Centre via online sign-in form or QR Code.
  2. before commencing work, all contractors must:
    1. complete the online Contractor Induction or appropriate alternative as approved by Property Services;
    2. present to Property Services or Security to confirm identity and obtain a swipe access card;
    3. obtain a contractor key set from the designated campus KeyWatcher cabinet;
    4. Provide Safe Work Method Statements, Safe Work Procedures and site specific risk assessment to the appropriate facilities supervisor for review;
    5. provide any Permits to Work to the appropriate facilities supervisor for review and approval;
    6. obtain identification and access keys or cards from the relevant location at clause 7(a); and 
  3. prior to leaving campus, contractors mus return Keywatcher Key Sets and sign-out at the relevant location.