Document Feedback - Review and Comment
Step 1 of 4: Comment on Document
How to make a comment?
1. Use this to open a comment box for your chosen Section, Part, Heading or clause.
2. Type your feedback into the comments box and then click "save comment" button located in the lower-right of the comment box.
3. Do not open more than one comment box at the same time.
4. When you have finished making comments proceed to the next stage by clicking on the "Continue to Step 2" button at the very bottom of this page.
Important Information
During the comment process you are connected to a database. Like internet banking, the session that connects you to the database may time-out due to inactivity. If you do not have JavaScript running you will receive a message to advise you of the length of time before the time-out. If you have JavaScript enabled, the time-out is lengthy and should not cause difficulty, however you should note the following tips to avoid losing your comments or corrupting your entries:
-
DO NOT jump between web pages/applications while logging comments.
-
DO NOT log comments for more than one document at a time. Complete and submit all comments for one document before commenting on another.
-
DO NOT leave your submission half way through. If you need to take a break, submit your current set of comments. The system will email you a copy of your comments so you can identify where you were up to and add to them later.
-
DO NOT exit from the interface until you have completed all three stages of the submission process.
(1) The Research Quality and Impact Committee (RQIC) is a subcommittee of the Research Committee which in turn is a subcommittee of the Academic Board. The RQIC is established to advise and make recommendations to the Research Committee on enhancing and monitoring the quality and impact of its research endeavours in line with the University’s strategic priorities and external benchmark standards for research. (2) The RQIC specifically addresses areas that complement the broader research oversight conducted by the Research Committee as the principal advisory committee of the Academic Board on issues of research across the University and by its educational partners. (4) The membership of Research Quality and Impact Committee is comprised: (5) The Chair may co-opt other members as required. (6) Appointed members will be appointed by the Senior Deputy Vice Chancellor taking into account appropriate gender diversity and participation of Indigenous Australians and students equivalent to appointees to the Research Committee. (7) Appointed members will serve for a period of two years, and for no more than two consecutive terms.Terms of Reference - Research Quality and Impact Committee
Section 1 - Purpose
Top of PageStrategic Advice
Monitoring Performance against Benchmark Standards
Policy Development and Compliance
Leadership, Coordination and Enhancement Initiatives
Section 2 - Composition